Home / Resources / What is double-ended tube chamfering?
Guide

What is double-ended tube chamfering?

Double-ended chamfering faces a tube and cuts a chamfer on the inside and outside edge of both ends in one automatic cycle, instead of one end at a time on a lathe.

The short answer.

A chamfer is a small angled cut that breaks a sharp edge. On tube, an ID chamfer bevels the inside edge, an OD chamfer bevels the outside edge, and facing squares the end. A double-ended machine does all of that to both ends at once.

Why it matters.

Chamfered ends slide into bores and fittings without catching, press in without shaving material, seal against O-rings without cutting them, and weld with better penetration. Sharp burrs are removed before they cut hands or damage mating parts.

Doing both ends in one cycle halves the handling of single-ended chamfering, and on high volumes that is most of the cost.

Where it's used.

Ferrules, bushings, sleeves and spacers; hydraulic and pneumatic tube; press-fit and slip-fit tube; mining and roof-support components; highway-safety and guardrail hardware; rack, furniture and frame tube.

How we do it.

Our automatic double-ended chamfering machine runs about 4,000 parts a day on typical parts, on tube up to about 3 in diameter and 12 in long. We chamfer tube you supply, or cut it on our tube laser first and deburr it after.

Questions.

What is the difference between ID and OD chamfering?

An ID chamfer bevels the inside edge of the tube end; an OD chamfer bevels the outside edge. Double-ended chamfering usually does both, plus facing, on both ends.

Is chamfering the same as deburring?

No. Deburring removes burrs; chamfering cuts a controlled angled edge to a size on your print. Chamfering removes the burr as part of the cut.

So, what do you want to build?

Send a model, a drawing or a napkin sketch. We'll price the part, the program or the whole product.